I make small scrapers (2" & 3") from the hard steel used in lumber strapping, the 1.25" wide stuff.
The wood work is quite small.
Cut with aircraft metal shears and tidied up with a chalked up file. One long edge squared off
with the file. I turn the file around and use the shank to create the burr.
Not very good at it yet but better than the shreddies with sandpaper.
The wood work is quite small.
Cut with aircraft metal shears and tidied up with a chalked up file. One long edge squared off
with the file. I turn the file around and use the shank to create the burr.
Not very good at it yet but better than the shreddies with sandpaper.
