I've been playing a game of too little/too much when spraying water based poly onto vertical surfaces.
If I put enough on to get a "full coat" then I risk getting runs. If I hold back on putting enough for a full coat, then I find I get orange peel. Is there a magic method for applying "just enough"?
(p.s. The project is too large to rotate it around so everything is horizontal when applying the finish.)
:blink:
If I put enough on to get a "full coat" then I risk getting runs. If I hold back on putting enough for a full coat, then I find I get orange peel. Is there a magic method for applying "just enough"?
(p.s. The project is too large to rotate it around so everything is horizontal when applying the finish.)
:blink:
