Woodworking Talk banner

4 x 8 panel cross cuts

14710 Views 14 Replies 9 Participants Last post by  SteveEl
This topic came up in another thread, and I had forgotten that I had an easy solution for occasional cross cutting 4 x 8 panels. I made a guide for my circular saw that is 90 degrees square to the length by using the factory end of the plywood to set up the guide. It's close enough for my work! :laughing: Two clamps keep the guide from shifting. Measure the distance from the saw blade to the saw base and add that dimension behind the cut line. In this case 1 1/2" clamp it up and saw away! :thumbsup: bill


See less See more
1 - 1 of 15 Posts
be aware also 4x8's dont always come square
measure the sheet corner to corner they if they match its square
1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.