Woodworking Talk banner
1 - 1 of 1 Posts

· Registered
196 Posts
Discussion Starter · #1 ·
I have a Chraftsman band saw #124.326607. The manual that came with the saw states the blade sizes start at 1/4". I would really like to use a 3/16" blade for sharper turns on boxes. Anyone have any experience doing this?

I would like to convert the bearings to cool blocks but I can't find much information on doing so. I have seen that Olson claims to have cool blocks for this saw but I am unable to find anything telling my how these work or if it's even possible.

I did see over in Lumber Jocks that a party did covert a saw like mine to cool blocks but I can't find it now.

Am I stuck with 1/4" blades? Or this there a way out?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.