Woodworking Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,903 Posts
Discussion Starter · #1 ·
When I run my lathe at real low speed, say 150-200 RPM, I sometimes hear a clunk, clunk, clunk sound. Does this mean a bearing is bad.

Part 2: If it is a bearing, where can I get bearings for a Powermatic 45?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top