Woodworking Talk banner

warp

  1. General Woodworking Discussion
    I've got a 2' x 3' piece of 3/4" oak plywood I had vertically clamped to an upright 2x4 shelf. Clamp was on one long side that didn't warp, but the opposite long side did warp some. Is it possible without a sweat box and only water and weights to flatten this piece? I would just like to...
  2. General Woodworking Discussion
    I am making some cabinets for a bar in my house. The doors will be approximately 16"w X 36"t. I was given a TON of walnut and would prefer to use that seeing it was free. I like the modern look of slab doors however I am worried about movement and warping especially if they are solid. Any tips...
  3. Design & Plans
    Would appreciate any thoughts on this interior door design. 4.5"-6.0" Walnut planks (6/4" finished thickness), glued together to a total width of 34", and a length of 8'. The idea is to make heavy, solid walnut doors, for this new home, that show off the grain in a somewhat modern design (no...
  4. General Woodworking Discussion
    Hi All: I'm still pretty much a noob in many ways when it comes to woodworking, so I apologize is this is a dumb question. I've been woodworking for maybe a year or two, but only in very limited stints as time and money allow. I've managed to aquire a decent set of tools, but the one thing...
Top