Woodworking Talk banner
Cancel

Search Results for ‘tool rest’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools hardware hardwood help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. Woodturning
    Hollowing out deep bowls on my lathe was always difficult because the tailstock was always in the way where I really needed the tool rest to be. So I bought 4 skateboard wheels, welded up a frame that attaches to the lathe base, and sliders to adjust the wheels up to the stock to hold it. It...
    bowl steady rest tailstock tool rest
  2. Woodturning
    Greetings all. As I continue to restore this Rockwell/Delta 46-450 lathe I am now wondering if there is a sleeve or bushing missing from the tool rest base? As seen in the photo, the base has an odd shaped multi-angled hole for the tool rest shaft to rest in, yet the shaft is perfectly round...
    46-450 rockwell tool rest
1-2 of 2 Results
Top