Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Woodturning
    Hollowing out deep bowls on my lathe was always difficult because the tailstock was always in the way where I really needed the tool rest to be. So I bought 4 skateboard wheels, welded up a frame that attaches to the lathe base, and sliders to adjust the wheels up to the stock to hold it. It...
  2. Woodturning
    I've been having trouble turning my tail stock hand wheel. I've greased and oiled it up real well, used a wire brush bit to clean it out, but it is hard to turn the quill through the first half of it. What I think happened to it -- the alignment plates underneath may have come loose due to...
  3. Woodturning
    I need to drill an oak 4x4 to accept a Morse Taper Tailstock for a treadle lathe I am building. Do any of you experienced turners know how I can drill a hole in oak for a morse taper tailstock?
1-3 of 3 Results