Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Power Tools & Machinery
    Hope everyone had a good weekend! Over the weekend, I was trying to cut some hard maple with my table saw and was continually having issues where the maple would get stuck between the riving knife / fence. The stock was cutting fairly well for the first part of the cut (so does not appear to be...
  2. Power Tools & Machinery
    My new used table saw has cabinet mounted trunnions so to adjust the blade runout you move the table. The blade is a little less than a 64th (64th is the smallest measurement I have) closer to the miter slot in the rear than the front of the blade. I followed the instructions to loosen the bolts...
  3. General Woodworking Discussion
    This is multifunction jig for table saw, can use for any jig combine with T slot. i build from HMR coz this material super flat, solid and very durable (waterprof). This jig can use for feather board for sacety cut without kickback, bevel cut, tenon and mortise joint. i think this jig can...
  4. Power Tools & Machinery
    Hey folks! (TL;DR just a bit down if you want to skip this) New to the forum here. A little background - I've been a lover of woodworking since I was young. In middle school I was in a wood shop club of sorts, and that's when I really discovered my love for the craft. Now, 15 years later...
1-4 of 4 Results
Top