Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. General Woodworking Discussion
    I put 3 coats of spar on a wooden table. Unfortunately, there was a lot of dust particles on it as can bee seen on the lower piece in the attached image. So after doing some research I sanded it down with 400 grit sand paper. I did this by hand and tried to be careful not to take too much off...
  2. Wood Finishing
    Good day folks......I'm working on a 36" round wood table top. I have stained it with Minwax water based stain. Applied 6 coats of Minwax water based Clear Satin Spar Urethane-then the last coat is-one coat of water based Clear Gloss Spar Urethane. It looks really nice and smooth and glossy and...
1-2 of 2 Results