Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Power Tools & Machinery
    My new used table saw has cabinet mounted trunnions so to adjust the blade runout you move the table. The blade is a little less than a 64th (64th is the smallest measurement I have) closer to the miter slot in the rear than the front of the blade. I followed the instructions to loosen the bolts...
  2. Power Tools & Machinery
    Hey guys, I bought a DWS780 12'' and I wanted to treat it with a good blade, but might have made a mistake. I bought a Festool 12'' 100T 0.120'' (so full kerf) miter saw blade. I do a lot of moldings and the blade is magnificent, the end grain is smooth as if I had sanded it and it fixed my...
  3. General Woodworking Discussion
    The glass patio table top shattered due to temperature extremes. I plan to replace it with a 3/8" MDO plywood. The top is roughly 3.5' x 6' and is oval. My options for cutting it are an older low-end jigsaw (which I think will work better to cut the oval) or an older low-end 7-1/4" circular saw...
  4. General Woodworking Discussion
    Here is a fun and simple project for the Folk art type of woodworker. http://www.youtube.com/user/willcfish?feature=mhum#p/u/87/F1FXOZ-64JM
  5. General Woodworking Discussion
    Hi all. I found this site today and was hoping you all could help me. I am going to build pull out shelves for the kitchen cabinets and have a few questions. <LI itxtvisited="1">What fastener should I use? 18ga Crown Stapler or 18ga Brad Nailer? <LI itxtvisited="1">For either CS or BN, what size...
1-5 of 5 Results