Hi all -
I am getting ready to stain and paint part of a furniture piece I am working on and have a few questions related to sanding. Part of the dresser I will sand, stain and poly. Other part of the dresser I will sand, prime, latex paint and possibly poly.
Sanding between poly coats (on top...
Well, the job was so close to being completed. And then I messed up the finish.
What happened was that I applied finish to one side and then let it sit too long. Something came up and it ended up sitting for a good bit. When I came back over I wiped off the finish and flipped over to start the...
I recently began tackling my first furniture project making a coffee table and matching end tables. Some of the furniture pieces my wife and I already have in our living room are white, so I have been attempting to paint these new tables white as well.
I am going for anywhere in between a...
I am making a vanity mirror with particle board.
I have done 4-5 layers of oil-based primer.
I have sanded it to 150.
I then used BEHR latex-based paint on it.
I did it twice.
wet sanded it with 220 grit sponge.
applied another layer (this time paint + Floetrol)
Later I tried sanding...
i recently built a side table out of pallet wood. the assembly was easy but i wish i had a pocket hole jig. i broke 2 bits trying to make the pilot hole at roughly 60 degree angles but they are cheap bits so i consider it a lesson. any way, for the legs i ripped a 2x4 in 2 and used some scrap...
Hi, This is my first project so I apologize in advance if I am not using the right lingo!
I want to take my two dressers from a golden brown to a dark chocolate brown. I sanded the original stain off using 120, 150, 180, 220 grit sandpaper with a sanding block and by hand. I used Rustoleum...
May I have the code number or spec number for the Scotch Brite pad? I went to my local HW store and they looked at me like I am crazy. They had only sponges by SB. May I have the Article number for the maroon pad to sand bewteen poly coats? Thanks in advance