Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Power Tools & Machinery
    Hi all, I'm looking to replace the stock blade on my 8.25 table saw. Per the riving knife , what needed is: .094 min kerf .079 max body thickness My question is about the circle with the line going through it on the riving knife. Any clue about what this symbolizes?
  2. Power Tools & Machinery
    Hope everyone had a good weekend! Over the weekend, I was trying to cut some hard maple with my table saw and was continually having issues where the maple would get stuck between the riving knife / fence. The stock was cutting fairly well for the first part of the cut (so does not appear to be...
  3. Power Tools & Machinery
    I have a Dewalt Contractor's saw, DWE 7492, European 220V version of 7491. As I wanted finer cuts than the blade that came with the saw would give me I purchased a thin kerf higher tooth count blade. I found that it does not work well with my standard riving knife. The knife being thicker than...
  4. Power Tools & Machinery
    I recently bought an older table saw that doesn't have a riving knife/ splitter, so I've been looking at options online, the mj splitter is one I've been thinking about, what about this though, do you think i could screw this on the underside of my ZCI? It seems like it would work... or am I...
  5. General Woodworking Discussion
    I have long been very frustrated by the above table dust collection arrangement on my TS. The dust chute was supported by the riving knife, and to make this possible, the knife was around 1.5" taller than the blade, so you had to take the knife off to be able to use a crosscut sled etc. Taking...
  6. General Woodworking Discussion
    I need to replace a standard 0.125" blade on my Grizzly 1023R that uses a rving knife. Grizzly says that the knive requires you to use a standard kerf blade as the thin kerf ones are thinner than the knife and they don't make one to match. I really would like to use the thin kerf ( 0.0904")...
  7. Power Tools & Machinery
    I have a Craftsman TS (#221140) and would like to remove the saw guard. Does anyone on this forum know of an after-market riving knife set-up that might work on this brand/model of table saw? Thanks in advance for your responses. Tom Goodson
1-7 of 7 Results