Woodworking Talk banner
replacement
1-7 of 7 Results
  1. Power Tools & Machinery
    I recently borrowed my friend's PC890 router, and while tightening a bit into the collet, the spindle lock pin broke right half in two. I have read that this is a common occurrence and that the vast majority of people don't bother replacing it, but since it doesn't belong to me, it certainly...
  2. Power Tools & Machinery
    I've been on the stinkin' internet for hours trying to figure out what to do about my 113.12173 Craftsman table saw motor. I am trying to replace it, but can't find a specific comparable motor. I can run the table saw, but I'm pretty stupid when it comes to fixing it! Any thoughts on an...
  3. General Woodworking Discussion
    Hey, my cabinet front has broken off, and all four plastic parts have been broken. Anybody know where to find these parts or solve the problem? I am not very handy. I am new here and I just made an account just for this :grin: The dimensions of the plastic thing is 1.5cm (width), 3 cm...
  4. Power Tools & Machinery
    Hi there, I have a Delta 36-979 10-inch left-tilt contractors saw that I purchased new back in 2009 or 2010. The saw has been in storage for years until I dusted it off this weekend. Unfortunately, the bright red throat plate became badly warped in storage (no idea how this happened) and one...
  5. General Woodworking Discussion
    Hi: I am a DIYer without much expertise in woodwork. Yet I have the urge to fix or replace a broken spindle of our dinning chair set of six. (I did dissemble and re-glue the loosen legs of one of them before.) I believe it is called "arrow back" Windsor dinning chair, which has those...
  6. Woodturning
    Hello, I am new to the forums, but was hoping someone here might be able to help me with my quandry. I recently purchased a Powermatic Model 90 wood lathe. One of the parts (90-912 the bottom spindle of the main belt) has a crack and wont secure tightly. I believe this is causing some...
  7. Power Tools & Machinery
    G'Morning! One last question about the Craftsman 113.241691 table saw... in another thread a bunch of folks helped get me up and running, and I learned a lot in the process (Thanks again!!). I'm sure I'll have more questions after I get my radial arm saw out of storage !!! :laughing: Here's the...
1-7 of 7 Results
Top