Woodworking Talk banner
Cancel

Search Results for ‘pulley’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 3 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drawer drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple milling miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. Woodturning
    Hey folks! Got a question: I’ve got an old Sears Craftsman Model 113.228162 lathe, and the other day I was turning a spindle on it. I turned off the lathe and noticed that the piece stopped rather suddenly rather than carrying on spinning while slowing down like normal. When I turned it on...
    lathe pulley sears crafstman spindle wood turning
  2. Power Tools & Machinery
    I have an atlas table saw from the 50`s. Runs fine but I put on a link belt and now the pulley on the saw arbor keeps slipping off the shaft. I have wrenched down the set screw and replaced the metal shaft key. This is very frustrating, anyone have any ideas? Thanks.:furious:
    link belt pulley
1-2 of 3 Results
Top