Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 8 Results
  1. General Woodworking Discussion
    I have a house that was built in the 1960s with log cabin siding. This siding was bought at a lumber yard, not custom made. I even went to the yard that sold it to my Grandfather who built the place. Now some of the pieces are rotted and it turns out NO ONE can get the exact siding I have...
  2. Joinery
    I've got a teeny tiny little shop and am in the early days of kitting it out. We've got a table saw, a mitre saw, an orbital sander, and some hand tools. I don't know that we're ever going to have room for a jointer, and while I'd love a benchtop planer we don't have that at the moment either...
  3. Power Tools & Machinery
    I have a DMC Top and Bottom sander, Can anyone tell me anything about it?
  4. General Woodworking Discussion
    The house we just bought has a sunroom with rough pine (or maybe cedar? not sure how to tell) siding in it. We would like to paint it white to brighten the space up, but I think this will look best if the wood is smooth (like shiplap). Wondering what the best approach to achieve this is. Should...
  5. Joinery
    Good Morning, I am new to the forum and had a question in regards to hand planing. I picked up some old reclaimed pine flooring and to clean up the top from the lacquer and other again I used a small hand planer. It gets the job done in removing shavings and I have a clean board, but I get...
  6. Joinery
    Hello all, I've got some really nice barn Chestnut that I want to use in a project or three, but it's got some problems. One if the boards is close to 13" wide, and 3/4" thick, and I want to use it in a headboard, showing off its width, but it's got some rather severe cupping going on such that...
  7. Wood Finishing
    I just purchased a Dewalt 735. I knew before I purchased it that one problem it had was life of the knives. I did not think it was as bad as I am experiencing. Dulling within just a few boards? Maybe I am doing something wrong with the planer, or maybe not. Planing barnwood, and I know this also...
1-7 of 8 Results
Top