Woodworking Talk banner
Cancel

Search Results for ‘oops’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drawer drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple milling miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. General Woodworking Discussion
    This weekend we squared up & glued two 10x36 paduak 4/4 boards to be used for a new standup desk. A little too late, we noticed one end of one board was warped. We should have noticed before we bought it, but didn't. It went through the planer ok. Water under the bridge, er money out of the...
    oops padauk warped wood
  2. Project Showcase
    I'll preface this by saying that I have built lots of stuff over the years, but this is one of the first things that I have made with the intention of having precise, solid joinery, not being over-built, and held together with only glue (and small screws for the hinges). I started with some...
    maple newbie oops recipe box tung oil
1-2 of 2 Results
Top