Woodworking Talk banner
Cancel

Search Results for ‘notch’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools hardware hardwood help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. Tips, Tricks, & Homemade Jigs
    Hello all, I needed to notch two 2x4s at both ends today. I thought about getting out the dado blades and spending the time to set them up, and then taking to time to make the several passes I would need, and then breaking the dado back down again. Then I thought, it would be a LOT easier and...
    notch safety table saw
  2. Power Tools & Machinery
    I'm new here and a novice woodworker. I'm trying to find the best way to notch a 4x4 to insert a 2x4. The only tool I have is a sliding mitre saw with a depth stop. My questions are as follows: 1. Is it safe to do this? 2. Because the cut will not go all the way through the wood, do you let the...
    kerf mitre saw notch safety
1-2 of 2 Results
Top