Woodworking Talk banner
materials
1-6 of 6 Results
  1. Wood Finishing
    Has anyone ever had a problem when edgebanding where there are glue spots that end up on the material? I have a Giben edgebander and recently we have been finding small glue spots on the material but a couple inches for the actual edge getting banded. Almost like the glue is spraying from...
  2. Trim Carpentry & Built-Ins
    Greetings! I'm planning out the build for my kitchen - a full remodel with cabinets built in my own shop. I was planning to use all 3/4" birch plywood for a majority of the boxes, and solid poplar frames. I've been comparing prices for sourcing the plywood and doing general research. I...
  3. Power Tools & Machinery
    So yesterday I was in the hardware store and found a Steel Grip Bench grinder. It has two wheels on it, and it's 1.1amp and 1/4HP. I have been hearing for a while about angle grinders, and how useful they are. However this was on clearance for $30 and I figured I should snatch it up if it comes...
  4. General Woodworking Discussion
    Hi, I'm designing a desk that I hope to build in the coming months, but I'm not sure what material would be best for longevity. I want this desk to be sturdy and last for many years without bowing. This is my sketchup design for this desk: Its 72" wide, 30" deep and 3/4" thick. It will sit...
  5. New Member Introductions
    I need to find lumber yards in or near Westchester, NY that sell basswood and other types of wood for carving. Any suggestions would be appreciated. Will travel for good deals and interesting stores/sales. Thanks!
  6. Design & Plans
    Hi, great forum! I have a fairly standard "10 X 10" L-shaped kitchen with a 48" island. After getting quotes that were reasonable, but lower quality construction or quotes that seemed unreasonable I am thinking of building my own boxes. I will likely buy the drawers, drawer fronts, and doors...
1-6 of 6 Results
Top