Woodworking Talk banner
Cancel

Search Results for ‘lamination’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools hardware hardwood help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. Tips, Tricks, & Homemade Jigs
    I started a relief on a 4'x2' piece of basswood and it is warping, i'm also worried that it is a bit thin in some of the lower areas and i haven't finished carving. I would like to be able to go quite a bit deeper without the worry that'll be to thin, thus needing to laminate another piece of...
    carving clamp jig lamination relief
  2. General Woodworking Discussion
    So I just glued up all the laminations about 24 hours ago with weldwood and all seemed to be great when I heard some creaking and cracking as I removed the clamps in three spots. There are three spots where it looks like the wood de-laminated a touch because I didn't use enough glue. I've been...
    bow building de-lamination lamination
1-2 of 2 Results
Top