Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

41-48 of 48 Results
  1. Joinery
    Any advice on joining some 12/4 red oak lumber together for a table top? I can use biscuits or dowels, but would like to know what works best. I have never joined anything so thick. Table will be 80" x 40", and the lumber I have is 12/4 and 10" wide. Thanks in advance, Ernie
  2. Trim Carpentry & Built-Ins
    Hello, We recently installed engineered wood flooring at home and are still in the process of putting down the thresholds. The threshold is between the wood floor and tile. The tile is a little shorter than the wood, by about 1/8". There are 3 areas that need a threshold: - Straight section by...
  3. General Woodworking Discussion
    he guys so i have gotten myself in over my head with the mindset you wont learn to swim in the shallow end. with that said my neighbor cut down a sycamore tree and after looking at this wood for about a month i thought i could turn these large chucks of wood into something so i decided on a...
  4. Design & Plans
    Good afternoon. Thank you for allowing me to join your forum. I have been a hobby woodworker for about 23 years and have built everything from shelves for my children to Shaker tables and cabinets. My reason for posting is the following: about 12 years ago I signed out a woodworking book...
  5. General Woodworking Discussion
    Hi everyone, I'm going to be starting a screen door project this spring and need a little advice. I'll be replacing the front screen door and building a new one for the back as it doesn't have one now. The basic layout and constructions is pretty simple but where my questions center around...
  6. Joinery
    I am building a baby bed and one of the tenons I cut is between a 1/16 and 1/32 to thin. I was hoping someone had a fix for my problem so I didn't have to remake the rail. I would appriciate any suggestions. Also, I have a couple of Mortises to cut in a curved side rail that is too tall for...
  7. General Woodworking Discussion
    I am trying to cut two pieces of wood to fit together with joinery integral to the seam. For example, I want to cut a wave patten on the edge of one board, and then make a negative of that cut on another board, so they fit together perfectly without the need for extra joinery. I can't use a...
  8. Joinery
    hey guys, i need some help with a project i am doing. its a wine cabinet with a few inset drawers. The drawers are killin me, i dont know where to start. could some one give me some advice? it would be much apretiated.
41-48 of 48 Results
Top