Woodworking Talk banner
Cancel

Search Results for ‘groove’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drawer drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple milling miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. General Woodworking Discussion
    Hi everyone, I'm an absolute beginner with access to a pretty well equipped shop. I want to cut a 1/2'' deep and 3/4'' wide groove in a piece that is about 3/4'' thick and 1.5'' wide. The groove is also very long relative to the piece, going almost its entire length (pic attached). What would...
    advice needed beginner help groove
  2. Joinery
    Hey guys, Hey guys, I am planning on putting up a reclaimed wood accent wall similar to the photos below: I have all of the lumber, but I am curious about opinions on jointing the pieces. I was thinking about using tongue/groove for the edges and possibly using biscuit joints for the...
    groove joint reclaimed tongue
1-2 of 2 Results
Top