Woodworking Talk banner
Cancel

Search Results for ‘flag case’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-1 of 1 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools hardware hardwood help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. General Woodworking Discussion
    Hey there, I recently built a tenoning jig and was sure to square everything before glue up. I built it to be able to cut the 22.5 degree miters for a memorial flag case. I have noticed that the height of the waste piece is taller by 1/8" on the leading side gradually getting shorter towards the...
    flag case please help!!!!! table saw issues tenoning uneven miters
1-1 of 1 Results
Top