Woodworking Talk banner

fix

  1. fixing warped plywood

    General Woodworking Discussion
    I've got a 2' x 3' piece of 3/4" oak plywood I had vertically clamped to an upright 2x4 shelf. Clamp was on one long side that didn't warp, but the opposite long side did warp some. Is it possible without a sweat box and only water and weights to flatten this piece? I would just like to...
  2. Finished box cracked

    General Woodworking Discussion
    I made a small walnut shadow box for a friend and after applying the first coat of danish oil finish the lid separated from the the wall of the box at one corner. The gap is only about the thickness of printer paper and extends about an inch in both directions from the corner. My first idea...
  3. Steam Bending board with Veneer

    General Woodworking Discussion
    Hi, this is my first time on this forum and im hoping someone out there can give me some advice. i have an old vanity w/mirror that i am refinishing. it has 3 separate tops, the middle section is 4" lower than the 2 sides. the problem is that it got some water damage at one time and the back 4"...
Top