Woodworking Talk banner

finger

  1. How to make Large Finger Joints

    Joinery
    Need advice on how to make large finger joints in the end of a 3"x6". I am trying to make a Nyquist Tail Vise and I am having problems trying to figure out how to accurately cut the joints with power tools. I have a table saw but the dado set is only 8" and will not cut three inches deep. Any...
  2. Clamping various joints

    Joinery
    I have a number of YouTube videos demonstrating the clamping of various joints that may be of interest to many woodworkers. You may want to check them out. They can be accessed through my web site: http://www.blokkz.com/. Good luck with clamping since it always seems to be a challenge.
Top