Search Results for ‘epoxy and poly’

Hey guys. I just did an epoxy flood coat on this piece of spalted maple. I want to use some poly as a finish. How would I do that? I have Varathane Oil Based Polyurethane and I have Minwax Wipe-On Poly (oil based). do I sand the epoxy down a bit, then put the poly/wipe-on poly on it? Do I use...

Hey guys. I’m working on a live edge spalted maple table right now. There’s a little crack in it that goes all the way through and I want to fill it with epoxy. Then put some sanding sealer on top, and finally some wipe on poly. should I put sanding sealer everywhere first? Including a bit on...

Newbie here, so feel free to correct me on anything. I've been working on this red oak (I think) cookie slab to use as a coffee table. I wanted to use an epoxy resin to fill the cracks and prevent dust from getting stuck in there. Question #1: Do you guys think I should epoxy fill the large...

Hey everyone. I'm new to this site. So... I got a garage and I decided to get myself a project. I bought an 8' by 2.5' x 2.25" thick slab of redwood sequoia. I've finished the router sled phase, and am now getting prepped to begin filling voids and cracks. I bought some "system three" clear...

Working on a table built out of old barn wood. Used System Three epoxy, and had some issues. Stripped most of it, except what filled the holes. Two days later, used Arm-R-Seal oil and urethane as a topcoat. Put it on 12 hours ago, and it is still very sticky. Is it possible that it is...

:eek:I am making rustic table that has about 8 worm holes about 1/4 to 1/2 inch wide and about 1 to 2 inches long. The wife wants to be able to see the holes but wants them flush. Can I fill the holes with epoxy and if so will poly adhere to the epoxy once it dries? Any other suggestions would...