Woodworking Talk banner
Cancel

Search Results for ‘cupping’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools hardware hardwood help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. General Woodworking Discussion
    I am a newbie wood worker and I am planning an outdoor table around 6ft long made of boards roughly 4in to 6n wide, probably oak or maybe cedar. I am concerned about the top cupping a while. To stop this, I was thinking of drilling horizontally through the boards and then feeding through...
    cupping table design warping
  2. General Woodworking Discussion
    I straightened out this bookmatched walnut live edge table by putting it over sawhorses, put hotplate and steaming water under it and covering it with plastic. It did the trick...it is flat once again! But, now how do I keep it that way? I have a kiln (foam box and dehumidifier)...should I put...
    cupping live edge straightening warped warping
1-2 of 2 Results
Top