Woodworking Talk banner
Cancel

Search Results for ‘cup center’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

advice antique band saw bandsaw bed beginner bench box brain teaser butcher block cabinet cabinets carpentry carving cedar chair cherry cnc craftsman delta design desk dewalt diy door drawer drill press drying dust collection epoxy fence finish finishes finishing furniture glue grizzly hand tools help needed introduction jet jig jigs joinery jointer lacquer lathe live edge lumber maple milling miter saw newbie oak paint pallet pallets pine plane planer plans plywood polyurethane power tools project question refinish refinishing repair restoration router router table safety sanding sharpening shellac shop sketchup slab stain staining storage table table design table saw tablesaw tool tools trim tung oil turning varnish veneer video walnut wood woodturning woodworking woodworking plans workbench
  1. Woodturning
    I'm just wondering: concerning the Nova Live Center System cup center for boring through a hollow tailstock: once you have the cup center point situated on the work-piece, how exactly does the cup then get re-aligned on center to begin boring, once you punch out the point? There must be...
    cup center hollow nova
  2. Woodturning
    I could really use some help. I am new to wood turning and have an old Sears lathe I am trying to learn on. It has a #1 Morse taper. The cup center is firmly stuck in the tail stock spindle. I have removed the spindle from the tail stock and soaked it in Liquid Wrench for over a week, but it...
    cup center remove cup center tail stock
1-2 of 2 Results
Top