Woodworking Talk banner
crown molding
1-5 of 5 Results
  1. Trim Carpentry & Built-Ins
    Can anyone suggest the best solution for installing my crown molding when the ceiling is unlevel by 1/2 an inch from front to back of cabinet? I started to put drywall mud on the ceiling to level it out, but it's so far off in such a short distance, I'm hoping there's another solution. Would it...
  2. Trim Carpentry & Built-Ins
    I am putting up angled crown molding on my new cabinets. I have most of it done, but I have come to a weird angle that I just can't figure out. The two cabinets form a 170 degree angle and with angled molding I have tried several different angles, but none work. Anyone tackled something...
  3. Trim Carpentry & Built-Ins
    Hi everyone- I'm trying to cut some 4.5 inch 38 spring crown for cabinets. Few 90 and a few 45 outside cuts. I'm using a 10" compound miter with short fence (Hitachi) so can't do the upside down against the fence method. I was wondering if there is a trick to setting the saw for those fraction...
  4. Wood Finishing
    Need help on Crown Molding on inset Trey Ceiling I am used to installing crown molding on flat drywall. However my current customer would like me to install crown molding at the top of her (recessed) trey ceiling. See attached picture; black marks show where crown molding is to be installed...
  5. Trim Carpentry & Built-Ins
    Delivered cabinets & built ins to a condo job today. Contractor has to install a series of moldings to form a crown around all the walls that lay flat on the wall & ceiling rather than at a 45degree, so there is no room for a nailer strip. It has been a long time since I have done installs, so...
1-5 of 5 Results
Top