Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. Power Tools & Machinery
    Hi, I bought a used craftsman tablesaw model number 113.298840. I had to adjust the trunion because my blade was not parallel to the miter guage. After I did that the belt was very loose on the pulleys. I bought a new belt and adjusted the motor according to the manual. I tested it by pinching...
  2. General Woodworking Discussion
    Afternoon! I need some help with the blade raising elements of my table saw. the model number is in the title. I Was raising the blade and something gave out, blade dropped. I only found one part in my clean up, a washer that’s somewhat cupped, doesn’t look like a traditional retaining ring...
  3. Power Tools & Machinery
    Hey Everyone, I was raising and lowering my table saws blade last night cutting the blade slot through some shop made zero clearance inserts, and all of a sudden the blade drops below the table!!! scared the hell out of me. I look down at my hand crank wheel and the wheel and shaft are...
  4. General Woodworking Discussion
    Hey everyone, my dad just upgraded to a Laguna Fusion 2, so he gave me his old craftsman saw from the 80’s. I have refurbished the saw, tuned it up and it’s mostly working great. The problem I have is with the original rip fence for the saw. I squared it up with the saws mitre groove, but it...
  5. Power Tools & Machinery
    Hey all, my first and only tablesaw that belonged to my grandfather let out the magic blue smoke a few days ago in the middle of a camper conversion project.. I took apart the 220v motor, and the temperature sensor around the rotor had burnt through, and I believe that led to it overheating and...
  6. Power Tools & Machinery
    I purchased this C-man 113.298842 a few days ago. It runs really rough. The motor without the belt attached runs smooth and I can’t feel any play in the bearings, same with the arbor/blade. This has a 1.5 Hp motor which I’ve read is heavy and known to stress the motor mount. When looking at the...
  7. Power Tools & Machinery
    Hi all, I recently bought a used Craftsman 10" bench saw (model no. 113.29943) and have had trouble getting it to work. I'm fairly new to both woodworking and machinery, so I'm not particularly knowledgeable when it comes to either. I was hoping I could find help troubleshooting on here and get...
  8. Power Tools & Machinery
    I just purchased an older Craftsman 113.29960 contractor table saw. I needed to upgrade from a benchtop table saw in order to get more consistent & accurate cuts as my carpentry side-job has grown. I am replacing some older parts that have worn out (pulleys & belt) but everything else is in...
  9. Power Tools & Machinery
    Hello, I inherited a craftsman floor drill press model # 113.213811 and seems to be running pretty loud and rough. There is a little wobble at the chuck but I'm not sure if it's the spindle or not. I plan on replacing the chuck, the quill bearings, the pulley bearing, and the belt with a link...
  10. General Woodworking Discussion
    I have an old 10" craftsman contractor saw. I've had issues getting the blade aligned to the miter slot. I posted a thread a couple days ago and got some good responses but its not letting me post a response for some reason, so I thought id start another after doing a little investigating...
  11. Power Tools & Machinery
    I did a search on this and didn't get any hits so will ask a questions here. I have an old '70s vintage Craftsman 113 tablesaw that works pretty well for my uses but I would like to retro fit a new fence - the stock fence is only so-so at best. Doing some internet searches I found...
1-11 of 11 Results
Top