Woodworking Talk banner

ceiling

  1. Trim Carpentry & Built-Ins
    Can anyone suggest the best solution for installing my crown molding when the ceiling is unlevel by 1/2 an inch from front to back of cabinet? I started to put drywall mud on the ceiling to level it out, but it's so far off in such a short distance, I'm hoping there's another solution. Would it...
  2. Trim Carpentry & Built-Ins
    I'm installing 42" tall kitchen cabinets in a 96" tall room. I'm assuming the ceiling isn't perfectly flat. How do I install the cabinets so that they are all at the same level? I cant seem to find any guides online on this. I'm assuming that I find the lowest point, and install them there. Then...
  3. Wood Finishing
    Hello, We are refinishing a large cedar T&G ceiling. We spent the last several weeks sanding the entire thing down to bare wood which was pretty tough, but now it is ready to go. We are trying to figure out what product to put on it. The room gets a lot of sun, so we are worried about products...
  4. Design & Plans
    i just got presented with a project that calls for the installation of reclaimed pine beams on a drywall ceiling. i am certain that the ceiling joists run parallel to the direction of the beams, so i can't necessarily guarantee the correct spacing if i am to anchor to them. since i can't very...
  5. Wood Finishing
    I'm hoping that you experts can help me. We have a beautiful high vaulted ceiling in our grand room that is natural wood tongue and groove panels. We are in the middle of a major kitchen remodel and recently took down the track lighting from the kitchen. The lighting doesn't work where it use...
  6. General Woodworking Discussion
    Pyramid vaulted ceiling This is a vaulted ceiling I built for a client, with no trim moulding so each of the compound mitre joints would show four crisp lines. The final four 16 ft. Pieces were scribed to the wall. Out of the thirty-two pieces of Fir, twenty-two of them were one single piece...
Top