Woodworking Talk banner
cabinet doors
1-8 of 8 Results
  1. General Woodworking Discussion
    Hi everyone. I Recently bought cabinets from RTAcabinetstore.com and I need to make some custom cabinet pieces that match the door frames. I contacted RTA and they will not give me any information about their cabinet maker so that I can find out what kind of shaper bits are used to make the...
  2. Trim Carpentry & Built-Ins
    I have a bi-fold cabinet full overlay door for which I need a left-opening mechanism (slide or arm). Door is ~17" total, each side is 8.5". I can't seem to locate anything. It's not a corner cabinet it's flat but in a tight space and needs to be accessed from the right side. So I built bi-fold...
  3. General Woodworking Discussion
    I am trying to determine an acceptable salary for a cabinet door builder. There are many listings on the internet for the average salary of a cabinet maker, but what I am unsure of is if there is (or should be) a difference between the salary of a cabinet door maker and a cabinet(box) maker? My...
  4. General Woodworking Discussion
    I am installing new kitchen cabinets and my wife wanted a corner cabinet installed right next to the under cabinet microwave. The issue now is that the door to the cabinet will only open 45 degrees. Does anyone know of a hinge that would extend out from the frame about 4 inches and then swing...
  5. Design & Plans
    Hello, this is my first post.... I've searched the forum but I haven't really come across the right info and was hoping to get some details here. I'm in the process of building a 90g aquarium and I would like the front doors to be flush. I think drawer slides will work well and help maintain...
  6. General Woodworking Discussion
    I have a client that would like to have this style door, I have made many raised panel doors, but am unsure how to go about this with the bead. Any suggestions/links to the appropriate bits? Thank You!
  7. Tips, Tricks, & Homemade Jigs
    Howdy! Anybody have any ideas on where I can find some clear vinyl cabinet door bumpers that are thicker than 5mm? I need 6.35mm height or a little more.
  8. Tips, Tricks, & Homemade Jigs
    I have 1940's kitchen built by hand (nothing impressive) and the cabinet doors have a 1/2 inch inset. I cannot for the life of me find any hinges that are self closing and have a 1/2 inch inset, so I would like to route out a small space to accomodate the more common 3/8 inch hinge inset size...
1-8 of 8 Results
Top