Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. Tips, Tricks, & Homemade Jigs
    I have a 84” x 14” x 1.5” piece of chestnut oak and want to cut a box joint at one end and use a 36” x 14” x 1.5” as the legs at one end of the future console table. I have both table saw and router table but can’t figure out how to cut the fingers at the end of the planks. What’s the best way...
  2. General Woodworking Discussion
    I want to make a 3/8 inch box joint jig for the table saw. I got out the Freud SD208S dado stack, and set it up for a 3/8 inch dado. According to the chart that came with the dado stack, the setup requires two blades and one chipper. Simple, huh? I made two test cuts in a 3/4 x 3/4 inch piece...
1-2 of 2 Results