Woodworking Talk banner
bosch
1-7 of 7 Results
  1. Power Tools & Machinery
    I recently purchased a Bosch 1617 router for use in my CNC Shark II but the chuck is too big for my 1/8" bits so I bought a collet chuck adapter to get it to fit. In theory it works but trying to replace a bit is somewhere between a real chore and almost impossible. It's just too tight and I...
  2. Tool Reviews
    Good day all ! I was wondering, has anyone used the new Incra Ibox jig for box joints with the Bosch 4100-09 table saw ? Please tell me what you like about it and or don't like about it. I have a fairly recent Bosch 4100-09 table saw. If you don't have a Bosch 4100 , but use the Ibox jig on...
  3. General Woodworking Discussion
    Ahoy all! I recently acquired a Bosch router table which I’m excited to work with. It’s the Bosch RA1181 Benchtop Router Table, and I was curious if anyone has any recommendations for a router to go with it. I currently have an old plunge router from Harbor Freight, so I’m looking to get...
  4. Power Tools & Machinery
    I have a Bosch 1617 EVS router. I just purchased a new dovetail jig and was working on learning the set up. When I go to the router part, I installed the 1/2" to 8 mm collet adapter. It is a slotted sleeve bushing that goes into the 1/2" collet. I put the dove tail bit into it and tightened...
  5. Power Tools & Machinery
    Hi There, I am looking to purchase a table saw, and its down to the Bosch 4100 or the Ridgid 5412. I have very limited space - a one car garage which would ideally store a car also when I am not building things, so storage space is a concern also, hence the Bosch 4100. I was wondering what the...
  6. Power Tools & Machinery
    So, what do ice cream and sliding compound miter saws have in common? Not a lot, but today the thought of buying the saw and a small bowl of Stone Cold chocolate ice cream are with me as I scribble this question. Got your attention, didn't it? :brows: Query; what are the two best rated 10" SCM...
  7. Power Tools & Machinery
    Bought a new bosch wormdrive circ saw (1677md) and I keep going back to my old underpowered standby. Even on a short cross cut (2x10) it is tailing off badly to the left. Any suggestions on adjustment/alignment? Improper use versus a standard circ saw? Lemon? BTW - It has not been...
1-7 of 7 Results
Top