Woodworking Talk banner
blades
1-10 of 10 Results
  1. Power Tools & Machinery
    I am looking for advice about the tiny, thin lines that appear on the surface of wood after running them through a power planer. I assume that my questions apply to most power planers. I have a used DeWalt DW735, which I bought several years ago. I recently flipped the blades over for the first...
  2. Power Tools & Machinery
    I bought an old craftsman jointer for $25 (my first one) why so cheap? The blades are discontinued. Except if you go to mywoodcutter.com they had the blades for my 4 1/8 jointer. Little pricey $45 but I'm off and running. They have a large selection. I hope this helps
  3. General Woodworking Discussion
    Hi all, I was recently given 2 old hand planes (pictures below). I am pretty new to fine woodworking, but would like to get these things into working condition. Unfortunately, the blades (and some other parts, I believe) are missing. I would really appreciate it if ya'll out there could help...
  4. Hand Tools
    What I have is a stack of three washers (3/8th inner hole) that have been steel-epoxy'd together to form a cylindrical stack. I need to do some shaping of this stack, and they are zinc-plated. What are some cheap options that could get the job done? I need to be able to cut one side flat and...
  5. Power Tools & Machinery
    So after a couple weeks of research I finally have enough of a clue to ask, which blade to buy? I have a 14" Grizzly. I want to do a lot of straight and curved cuts on mostly 2x4 pieces of wood. I was thinking a 1/4" blade for curves, and a bigger one for straighter cuts. TPI is still...
  6. Design & Plans
    Hey Guys, I am trying to make a scratch stock beading tool and I can't seem to get the blades right. I picked up some steel at my local lowes and filed a simply bead into it. My issue is that it is not sharp enough to cut. I've been watching all these vidoes on them and it just shaves the...
  7. Power Tools & Machinery
    Hi, I am a new wood worker and have aquired a planer (13" bench planer). I have been making many shallow cuts instead of fewer, deeper cuts. While I find it pleasurable to spend the time making many passes (I am a hobbyist), I started to think that my method will cause the blades to dull more...
  8. Power Tools & Machinery
    Is it possible to run 8" dado blades on a ten inch table saw? the arbor size is the same and the rpm on the blades is still with in the specs for the saw. I got a set for x-mas and I don't really want to have to exchange them. I don't need them very often but I figure if I can still run them...
  9. Power Tools & Machinery
    Sort of a follow up to my previous question. I understand that whatever saw I buy, I'll want to replace the blade with something nicer. I'm thinking I'll need two blades, one for resawing 5 - 6 inch mahogany, walnut, cherry, and similar woods down to 1/8 inch. The other will be for roughing...
  10. Power Tools & Machinery
    So I am new to the woodworking scene in the past few months but so far I LOVE IT. I took a few classes at a reputable college in Seattle and have started to look for some used power tools to start building a bit of a shop. Anyway a guy at work sold me his old 6" Mark 1 jointer (Model SJ-1503UL...
1-10 of 10 Results
Top