Woodworking Talk banner
blade alignment
1-5 of 5 Results
  1. Power Tools & Machinery
    I can't find much on this table saw. The slot to blade doesn't appear to move enough to get it parallel. I've tried all kinds of combinations of what to loosen and what to leave snug. Anyone fight that battle and win? The fence seems OK. It adjust for square to slide. But I don't see how it...
  2. General Woodworking Discussion
    I have an old 10" craftsman contractor saw. I've had issues getting the blade aligned to the miter slot. I posted a thread a couple days ago and got some good responses but its not letting me post a response for some reason, so I thought id start another after doing a little investigating...
  3. General Woodworking Discussion
    Help! I've read a few threads both on here and other forums, but I can not find a solution. I've just purchased a used (obviously) 10" Craftsman Contractor table saw Model: 113.298842. I have been trying to get the blade aligned to one of the miter slots to no avail. I've spent the last three...
  4. Power Tools & Machinery
    I'm having some alignment problems with my 20-year old Delta contractor saw, model 34-444. Facing the saw from the front, the blade is too far to the right. At 45 degrees, the blade almost touches the tight edge of the slot in the table insert. I've tried loosening the 4 trunnion bolts and...
  5. Power Tools & Machinery
    I've got a used Craftsman tablesaw, model 315.228410, and the blade seems to be out of alignment. When I measure to the miter slot, it's 4" on the front but about 3 7/8" on the back--nearly an 1/8" out over the 10" blade. Doesn't that seem like a lot? I have the manual, and it says that I need...
1-5 of 5 Results
Top