Woodworking Talk banner
belt
1-5 of 5 Results
  1. Power Tools & Machinery
    Hi all, I have a Delta 36-600 10" table saw. It uses a notched belt ("timing belt") with matching teeth on the drive shaft so it cannot slip. When this saw starts up it comes to full speed in about 1/2 second. The inertia of the arbor and blade puts a huge strain on the belt (and other...
  2. Power Tools & Machinery
    I have a Delta 34-670 table saw. I am going through drive belts about one per year after only light-moderate use. I've replaced the bushings, and I don't see anything visibly defective in the belt area. I'm at a loss as to why these belts are wearing down to smooth so quickly. I'm starting...
  3. Power Tools & Machinery
    Hi Everyone, I'm new to the site, and hoping all you experienced wood workers can help with some advice. I do a lot of creative work with some really hard exotic woods, and recently also a lot of work with large bones, antler, etc. Over the years I've used several brands of the commonly...
  4. Power Tools & Machinery
    First drive belt lasted 5 years. Now installing 3rd drive belt in last six months. Drive bearing seems ok and no other apparent problems. Any suggestions or similar problem.
  5. Power Tools & Machinery
    Hi all, Can anyone tell me the proper size of the PowerTwist Plus link belt to order for the Delta 34-444 TS? I ordered a 1/2" but it isn't fitting the pulleys properly. Is the 3/8" found here a proper fit...
1-5 of 5 Results
Top