Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. General Woodworking Discussion
    Hey folks! Very grateful for this community. A question, I do highly detailed engraving into baltic birch using a CNC mill. This goes great, except that the inner cores of baltic plywood are often quite full of knots. Usually it's not an issue, but once in a while a big knot ends up right in a...
  2. General Woodworking Discussion
    Today I was going to buy a 5' x 5' sheet of 18 MM Baltic Birch plywood. Grade was B/BB. I hope you are sitting down. It was about $140 per sheet!!! I even asked them to verify the price. Obviously I didn't buy it.
  3. Project Showcase
    Made out of 2x4s and some plywood. I kept it "open" so damp clothes won't mildew and it's possible to see and pull out an article of clothing down in the pile without dumping everything out. Has one coat of Arm-R-Seal on it.
  4. Wood Finishing
    Hello all. I've done very little with staining and really don't know what I'm doing. I've done some tests on the baltic birch plywood that I am using for a shelving unit with the hopes of staining it darker. The plywood is faced with cherry. Attached is a photo of a test piece of the...
  5. Design & Plans
    Hello, I'm going try to build a guitar speaker cabinet out of MDF in 3/4 I was going to use Baltic birch but the cost in a little to high for me anyway my question is can rout the edge of MDF board once its all together using a round over bit? or will it chip up or splinter? I ask this because I...
1-5 of 5 Results
Top