Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. General Woodworking Discussion
    Working on a "multi-piece" desk build. Too large to do a single piece, so I'll have to connect the pieces after install. I've used drawbolts before and they work good, but it's a bit of work to drill all the holes and do the setup. I found these brackets on Amazon, anyone ever try them...
  2. Joinery
    Hi Folks, I have looked at clips but have had difficulty finding ones that would work with this type of design. So I'm thinking of 3x countersunk slots and attaching lag type screws drilled up through the bottom of the cleat. 1x screw per board. The hope is to be able to lift the table by...
1-2 of 2 Results