Woodworking Talk banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. General Woodworking Discussion
    Hi All: Envision a piece of plywood, say 3/8” in thickness. Now, envision that a tiny box is cut out of one side of the plywood, some distance from its edges, say 1/8” deep, by 1/2” wide. Envision that the piece of plywood is, say, 3/8” in thickness. Now envision that this tiny box is cut...
  2. General Woodworking Discussion
    Hi, I am building a bird feeder and used two 30° miter cuts on the top that meet like a triangle. I thought a 30° bevel cut would work for a roof... however it did not. I attached a very rough sketch. How do I find the angle to make my two bevel cut to fit the miter cuts? Thanks for your help.
  3. Power Tools & Machinery
    I recently purchased a Ridgid TS3660 Table saw used. It looks brand new. It looks like its hardly been used a all. I went through it and made all the alignment adjustments using the user manual. I have ben using it a lot with 90 degree cuts. When I went to check the 45 degree stop point, it...
  4. General Woodworking Discussion
    Hey woodworking gurus. I am a n00b to wood working but I am trying to learn to do a lot more things myself. I didn't grow up working with my hands much. 1st on the docket is a 2 dog, doghouse. As I am drawing up the plans and creating a cut list I have run into a snag and I can't figure out how...
1-4 of 4 Results