Join Date: Nov 2014
Location: Huntingdon Cambs UK
It's a module for the CMS. It's not available in North America. Mine is for a TS 75. I also bought a side extension table and a fence that fits the CMS but is designed for the CS 50.
It does a good job. Not the best cut compared to the stationary Delta I gave away in the states before I came here, but a good one.
I like it because it is a definite space saver. If I need to rip some small strips, I use my saw, pull the module out replace it with my scrolling module that uses the jig saw, then pull it out and put in the router module...
It is a pretty slick system. Since this photo was taken, I bought another CMS that goes on the MFT. That way I can have 2 modules at once.
I made some of my own modules. I mounted my disk/ belt combo sander to some ply and just pull out what ever module I have in it and replace it.
The modules are stored on spur shelving mounted to the wall so they don't use a lot of space. I have some ideas for more modules but have to wait til I get back to the states to build them.
I did go with out a table saw for a while and used just the saw and guide rail with the MFT . The table saw does make things go a bit faster.