I finally have a scroll saw again. My wife bought it for me, a PerforMax from Menards.
Yes, I know, it is a cheap, and slightly underpowered saw. But, it is a scroll saw. I haven't had one since 2002 and I lately have been bitten by the scrolling bug again, and now I can do something about it.
We recently moved, and somewhere, somewhere, I have a couple large boxes full of pattens, but can't find them right now, so I surfed the net last night and found some guys site with quite a few scroll saw patterns for free. So I printed one off, altered it a little, and spent the morning in my cold garage, making saw powder.
I have missed this.
I have all the peices cut, now they just need a light sanding, assembly and a finish applied, once I get that done, I will post pics.
I will say, I started out and could easily see, I was out of practice, but by number 3 of 9 pieces, I was right back at it, tho a bit slower than I use to be, also seems like the lines on patterns have gotten a bit blury over the past 11 or 12 years
anyway, just wanted to type for a minute cause I am excited to once again, be scrolling.
now to save up for theat 20 inch DeWalt scroll saw....