Junior Member
|
Thread Tools | Display Modes |
Cleaner?
What is the best thing I could use to clean my shaper table top?
Sponsored Links | |||
Advertisement |
|
It depends, what's on it? grease? dirt? paint? I'd use WD40 or other spray lube, any silicon free product. Mineral spirits will remove grease and grime. I use Gibbasize on my tools. It's a light oil product: http://gibbasize.info/index2.html
The answer to your question will only be as detailed and specific as the question is detailed and specific. Good questions also include a sketch or a photo that illustrates your issue. (:< D)
Senior Member
I bet it's surface rust. I sand mine with 320 grit sandpaper and wax with Johnson paste wax.
Sponsored Links | |||
Advertisement |
|
Junior Member
It's basically dirt, grease and glue.
Senior Member
A sharp scrapper for the glue.
After that I do the same as Woodsandthings except I use fine steel wool instead of sandpaper.
George
After that I do the same as Woodsandthings except I use fine steel wool instead of sandpaper.
George
Senior Member
I typed one message and another one posted. Basicly said the same thing Cabinetman said only I'm too cheap for Top Cote. I use Johnson Paste Wax.
Last edited by Steve Neul; 03-31-2012 at 10:41 AM. Reason: computer glitch
For glue...a scraper or chisel, or a putty knife/spatula. For grease and dirt...mineral spirits, or lacquer thinner. For rust, wet-or-dry silicon carbide sandpaper if very bad, or a micro fiber pad. I wouldn't use steel wool...shards from it can rust. Bronze wool, or stainless steel wool, or a synthetic "wool". For a treatment, Top Cote works pretty good.

.


.
Photos - 4 Pages: http://www.woodworkingtalk.com/galle...00&ppuser=1269
«
Previous Thread
|
Next Thread
»
Thread Tools | |
Show Printable Version Show Printable Version
Email this Page Email this Page
|
|
Display Modes | |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
air cleaner motor from box fan? | wilbwworker | Dust Collection | 27 | 08-27-2011 08:14 AM |
DIY air cleaner/filter | Gene Howe | Tips, Tricks, & Homemade Jigs | 32 | 07-23-2011 09:36 AM |
Blade Cleaner ( Oven Cleaner ). | Woodsphere | General Woodworking Discussion | 5 | 04-08-2011 12:34 AM |
Ambient air cleaner help please. | xphnmn | Dust Collection | 6 | 04-08-2011 12:10 AM |
Air cleaner opinions | chubbyhubby | Power Tools & Machinery | 4 | 04-01-2010 06:31 PM |
Posting Rules | |