Nice little weekend project to keep the mind busy.
Made bigger wings and storage for my Delta 36-725
Under the left wing I made a little slide out holder for saw blades that only sits about an 1 1/2" below deck.
Oh and I also like to paint everything.
I have a small garage and was building something else to the right of my saw this past weekend.
The extra wing on the right side has already created a nice work space tools and whatnot.
I was originally going to build a 24" x 27" box to fit in that spot but I was hesitant to try and get it square and bolted in so I built it a piece at a time.
I put my main piece in place along the main table side and built out from there.
I made a 1/2" spacer on the hinge side to bump it out a bit from the rail a bit.
The only problem I had was not being able to open the door completely vertical without putting stress on that hinge.
The top is 3/4" MDF so i dont want those screws to pull out.
I actually found some chains on mounts at work and used those to limit how far it will open.
I will try to get a picture tonight.
Its really just a 1/4" piece of hard board that slides into two wooden rails with grooves. Real simple just to hold a few blades.
I have the same saw. I used the right side to drop one my router into a peice of MDF . Has plenty of space and makes nice use of the fence. I might have to do something similar to your on the left side.