Need Instructions On Craftsman Table Saw
Have a 10 " table saw and need to replace arbor shaft and bearing. Have correct kit/part from Sears but at a loss as to how to remove worn unit and install the new one.What is the simplest way to remove the old shaft and bearing.
Can`t get at it from back of saw and not from the front.Do I have to remove two steel wing extensions and then remove the machined cast iron top to access the unit?
Probably can figure out how to remove and replace the part if I could only see what I`m doing and get a wrench or other tool in there.
Or, is there an easier way? Appreciate any help you can provide.Regards: nad from Maine.