Jet jointer 6csx infeed table adjustment problem
Just finished tuning up the jointer and now I'm left with a big problem. I cannot get the infeed table up any higher than a 1/16" cut. I want it half that shallow. Yes, I've cleaned, scrubbed and blown out the adjustment mechanism to no avail. It appears that there are two washers on the adjustment screw shaft that are jamming it and preventing it from turning any further. I don't see them on the parts diagram; can't figure out why they are there to begin with and can't figure out how to get them off. Any help out there? Sign me Frustrated as Hell P.S. the jointer is over 15 years old and I simply don't remember if this was a problem when I last used it years ago.