How To Adjust Bevel On Ryobi 1346 Miter Saw
Anyone have one of the Ryobi Miter saws ? I have the 1346 TL and cannot for the life of me adjust the bevel from O degrees.
I am following the owners manual step by step. No dice.
The only thing I can figure is the lock pin only comes out about an 1/8" and the saw doesn't raise any higher than the normal.
Well, I sprayed some WD40 on the contact surfaces and played around with it.
Finally got it working. Had to spin the miter adjust over to the 45 degree mark and then it just magically allowed me to adjust the bevel.
Last edited by against_the_grain; 05-21-2013 at 03:33 PM.