Woodworking Talk banner

Riving knife setting

2K views 9 replies 5 participants last post by  TrevortdogR 
#1 ·
This is the bat I can get it so Is this acceptable front to back?
Front:
Technology Electronics Electronic device Machine Gas


Back:
Electronics Technology Machine Electronic device
 
See less See more
2
#2 ·
if referenced off a tooth, theoretically the stock should pass. you want to check both sides. being that close will not allow for any deviation of the knife.


i actually prefer the riving knife to be thinner than the blade. the blade kerf size plays a role with the knife.


is that home made?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top