Woodworking Talk banner

Cutting crown flat for vaulted ceilings

2K views 8 replies 5 participants last post by  TimPa 
#1 ·
I have found plenty of charts and calculators to cut crown flat for horizontal corners but can't seem to find one for vertical angles. I am using a crown too large to set in the saw at an angle so need to cut it flat.
Is there a chart or calculator or just a simple rule I can follow?

Thanks
Stuart
 
#5 · (Edited)
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top