Woodworking Talk banner

Ridgid TS3660 Dado throat plate

9K views 6 replies 5 participants last post by  Davet 
#1 ·
Anyone know the part number for the dado throat plate for the ts3660 ridgid table saw? I cannot find the part number on ridgidparts.com only the standard throat plate. I guess I will call the 800 number if all else fails.

Thanks,
Shane
 
#2 ·
I have a Griz but I make my own inserts. I use MDF but plywood would work well too. I double stick tape the original insert to the MDF, cut it fairly closewith the bandsaw then trim to size with a pattern bit on the router table. I also put in 4 flat head screws to adjust for level.
 
#7 · (Edited)
Click on the parts list icon upper right on this page.

Should be item #6 TH100050 THROAT PLATE INSERT .

Dave
Whoops! that's what I get for trying to post on the way
out the door,,, Sorry! :1eye:
TH100050 Is the standard clearance plate.

This page has the manual and the parts list.
Ridgid also has a real good forum also.

http://www.ridgid.com/Tools/TS3660-Table-Saw/EN/index.htm

You can also buy after market plates or make them
yourself.
 
#5 ·
I have a Delta TS, but also make my own. I buy the white plastic cutting boards in the kitchen section of Walmart. It is about .5" thick, slick as grease, tough and cheap. Follow Johnv51's procedure.
Of course, MDF is even cheaper. I have cutoffs of that laying around.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top